Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center ste
HOLLEY H. gave our service a 5 star review on 6/25/2026
WHEEL HUB – Remove & Replace – 4WD Front, One Side – [Serviced with Wheel Hub Assembly.]
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center ste
GARY L. gave our service a 5 star review on 4/9/2026
Verified customer concern of check engine light and engine misfire. Scanned vehicle and found codes P0302 cylinder 2 misfire and P219B bank 2 air/fuel ratio imbalance. Confirmed misfire on cylinder 2. Removed upper intake manifold for inspection. Spark plugs inspected and measured at .052 gap. Tested fuel injector resistance and found cylinders 1, 3, 4, 5, and 6 around 14 ohms (within spec). Cylinder 2 injector measured 33 ohms, indicating internal failure causing improper fuel delivery and misfire. Recommend replacement of cylinder 2 fuel injector, spark plugs, and upper intake manifold gaskets, then clear codes and verify proper operation.
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
INSTALL 4 TIRES LIFETIME BALANCE AND ROTATE
TOM R. gave our service a 5 star review on 10/17/2025
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
4 TIRE ROTATION CHECK AIR PRESSURE SET TO SPECIFICATION
Install and Program TPMS Sensor
MICHAEL S. gave our service a 5 star review on 7/7/2025
Lubricate and check chassis. Change oil and oil filter. Check air filter and breather filter. Check all fluid levels and tire pressures. Preform basic safety inspection. Road test vehicle.
4 TIRE ROTATION CHECK AIR PRESSURE SET TO SPECIFICATION
KEN F. gave our service a 5 star review on 1/31/2025
VEHICLE INSPECTION- Customer states front end feels "clunky" and pulls on uneven roads. Requests suspension be checked- Check and Advise
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check alignment of all four wheels. Adjust caster, camber, toe-in, and thrust angle as needed on all four wheels. Center ste
Front Left Lower Forward Control Arm. – Remove & Replace – One Side – [DOES NOT include alignment.]
AXLE SHAFT OIL SEAL – Remove & Replace – One Side
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
Inspect hoses and clamps. Pressure test cooling system. Flush engine, radiator, and heater core in both directions. Bring antifreeze to -35 degrees. PH balance coolant to between 9.8 to 10.5. Check thermostat and electric cooling fan operation. Chec
DAVID S. gave our service a 5 star review on 1/15/2025